Replacing An Smu - Huawei ETP4830-A1 User Manual

ETP4830-A1 Embedded Power
User Manual
Figure 7-1 Removing a rectifier
Step 4 Push the locking latch on the new rectifier towards the left, and pull out the handle.
Step 5 Place the new rectifier at the entry of the correct slot.
Step 6 Gently slide the rectifier into the slot along the guide rails until it is engaged. Close the handle,
and push the locking latch towards the right to lock the handle, as shown in
Figure 7-2 Installing a rectifier
Step 7 Remove the protective gloves.
----End
Follow-up Procedure
Pack the removed component and send it to the local Huawei warehouse.

7.4.2 Replacing an SMU

Prerequisites


Procedure
Step 1 Push the locking latch towards the left.
Issue 10 (2017-08-08)
You have obtained an ESD wrist strap, a pair of protective gloves, an ESD box or bag.
The new rectifier is intact.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Maintenance
Figure 7-2.
54