Siemens SIMATIC S7-1500 System Manual page 176

CPU display
②
Regarding : Names of the menus
The following table shows the available menus of the display.
Table 12- 2
Main menu
items
176
Names of the menus
Meaning Description
Overview The "Overview" menu contains information about the properties of the
CPU and the properties of the inserted SIMATIC memory card, as well
as information on whether a know-how protection or a linking of the
serial number exists.
For F-CPUs, the status of the safety mode, the collective signature and
the date of the last change in the F-CPU is displayed.
Diagnostics The "Diagnostics" menu includes:
Display of diagnostics alarms
•
Read and write access to force tables and read access to watch
•
tables
Display of cycle time
•
Display of the CPU memory utilization
•
Display of the interrupts
•
Settings In the "Settings" menu, you can:
Assign the IP addresses and the PROFINET device names of the
•
CPU
Network properties of each CPU interface
•
Set the date, time, time zones, operating states (RUN/STOP) and
•
protection levels
Disable/Enable display with display password
•
Perform a CPU memory reset
•
Perform the reset to factory settings
•
View the status of the firmware update.
•
Modules The "Modules" menu contains information about the central and
distributed modules that are used in your configuration.
Peripherally deployed modules are connected to the CPU via
PROFINET and/or PROFIBUS.
You can set the IP addresses for the CPU or a CP/CM here.
Fail-safe parameters are displayed for F-modules.
Display In the "Display" menu you can configure settings related to the display,
such as language setting, brightness and energy-saving mode. The
energy-saving mode dims the display. The standby mode selectors the
display off.
Automation system
System Manual, 12/2014, A5E03461182-AC