HP 3PAR StoreServ 7000 Service Manual page 37

5. Type 1 and press ENTER to continue with the new installation.
Type of install
Enter Control-C at any time to abort this process
How do you want to configure this SP?
1 ==>
2 ==>
X None of the above. Cancel and Exit
1
6. Press ENTER to accept the default SP name (in brackets) or type an alternate name and press
ENTER. The default SP name is the SP serial number. HP recommends accepting this default.
SP Network Parameters
Enter Control-C at any time to abort this process
Valid characters are [a-z] [A-Z] [0-9] dash(-) underscore(_)
Please enter the host name [SPXXXXX] : [enter]
7. Type the static IP address assigned to the SP and press ENTER.
SP Network Parameters
Enter Control-C at any time to abort this process
Please enter the IP address for the public network interface:
<static.IP.address>
8. Press ENTER to accept the default subnet mask, or type an alternate subnet mask for the SP
and press ENTER.
Please enter the netmask for this interface [255.255.255.0]:
<subnet.mask.address>
9. Press ENTER to accept the default gateway address shown in brackets, or type an alternate
default gateway address and press ENTER. The setup script suggests a default gateway address
based on the IP address you supplied.
Please enter the IP address of a default gateway, or NONE [<static.IP.address.1>]:
<default.gateway.address>
10. Press ENTER to accept the default network speed or type the network speed and press ENTER.
Please enter the network speed (10HD,10FD,100HD,100FD,1000HD,1000FD,AUTO)
[AUTO]
Continue with spmob ( new site install )
Restore from a backup file ( SP rebuild/replacement )
Manually Setting up the Service Processor 37