Mixed Connectivity Setup - HP 3PAR StoreServ 7000 Service Manual

45. Press ENTER to conclude Service Processor Setup Wizard configuration.
InServ configuration is no longer done during the Moment Of Birth.
Use spmaint after a successful MOB to do that configuration.
Press ENTER to continue. [ENTER]
NOTE:
must first be installed in order to communicate and add an HP 3PAR Storage System. To install
OS files, see
CAUTION:
system have not been properly configured. Verify the IP addresses on the SP and controller
nodes. Use the red crossover cable to connect the highest node port ETH 0 to SP ETH 0 to
establish a private network.
NOTE:
Service Processor" (page
46. Monitor the system while the SP uses the site key. When the system communications
configuration is complete, the following message appears:
*** starting final MOB phase
Updating PAM settings
Rebooting....
The SP automatically restarts.
Welcome to the 3PAR Service Processor Moment of Birth
Rebooting....
Continue to

Mixed Connectivity Setup

Use the following procedure to set up the SP at a site where monitoring the storage system and
external communication occurs through the customer network. Remote control of the SP occurs
through a serial modem connection using a customer-supplied dialup number.
1. Connect the maintenance PC to the SP through serial connection, then power on the SP and
log in as the root user.
2. Press ENTER or type yes and press ENTER to begin the SP setup script (Service Processor Setup
Wizard).
3. Press ENTER or type no and press ENTER.
CAUTION:
other defined connection system. A complete rebuild of the SP is required if the SP needs to
establish communication link with HP Central.
50 Installing Storage Software Manually
After completing the Service Processor Setup Wizard process, additional OS files
"Installing HP 3PAR OS Files " (page
If you receive any Password: prompts during this process, the nodes in the
To add a cluster after installing 3PAR OS files, see
62).
Fix passwords
Enabling key change on reboot ...
Disabling sendmail...
verifying postfix status...
Setup to run all ST/SP tasks at boot time
Add SPID to ppp id
Cleanup MOB
"Installing HP 3PAR OS Files " (page
If you answer yes, the SP is not able to communicate with HP Central, or any
61).
"Adding a Storage System to the
61).