Adding A Storage System To The Service Processor - HP 3PAR StoreServ 7000 Service Manual

1
6. Type 1 for Display SP Version to verify installation is complete.
1.1
SP-2.5.1.GA-15
SP Base Image Version:
SP Version:
SP Patches:
InFormOS release (3.1.2):
More detail is available in the latest SPLOR or spconfig data.
Press <enter/return> to continue
Continue to "Adding a Storage System to the Service Processor" (page

Adding a Storage System to the Service Processor

After successfully completing the Service Processor Setup Wizard, you must add the storage system
to the configuration database of the SP. Adding the storage system permits the SP to communicate,
service, and monitor the health of the system.
To add the storage system to the SP:
1. Connect the maintenance PC to the SP.
2. In the SPMaint, type 3 and press ENTER to select InServ Configuration Management.
SPXXXXX
3
62 Installing Storage Software Manually
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> InServ Configuration Management
4 ==> InServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for an InServ
X Exit
Display SP Version
SP Software Version
1 SP Main
3PAR Service Processor Menu
Transfer media: ethernet
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> InServ Configuration Management
4 ==> InServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for an InServ
X Exit
3.1-8
2.5.1.GA-15
3.1.2.226
Transfer status: No transfer yet
62).