D-Link DAP-1610 User Manual page 70

DAP-1610 AC1200 Wi-Fi Range Extender
User Manual
In the opened window, specify the needed parameters:
Parameter
Speed
To enable the needed data transfer modes, move relevant switches to the right.
Symmetric flow control
After specifying the needed parameters, click the SAVE button.
Data transfer mode.
Select the auto value to enable autonegotiation. When this value is
selected, the Autonegotiation Modes and Flow Control
sections are displayed.
Select the 10M-Half, 10M-Full, 100M-Half, or 100M-Full value
to manually configure speed and duplex mode for the selected port:
10M-Half: Data transfer in just one direction at a time (data
•
can be either sent or received) at the maximum possible rate
of up to 10Mbps.
10M-Full: Data transfer in two directions simultaneously
•
(data can be sent and received at the same time) at the
maximum possible rate of up to 10Mbps.
100M-Half: Data transfer in just one direction at a time (data
•
can be either sent or received) at the maximum possible rate
of up to 100Mbps.
100M-Full: Data transfer in two directions simultaneously
•
(data can be sent and received at the same time) at the
maximum possible rate of up to 100Mbps.
Autonegotiation modes
Flow control
Move the switch to the right to enable the flow control function for
the port.
Move the switch to the left to disable the flow control function for
the port.
Page 70 of 91
Configuring via Web-based Interface
Description