Table of Contents
Advertisement
1 Health & Safety
1.1 Document symbols
Symbols that may appear in this document are shown below:
DANGER – Serious damage to health / risk to life
This symbol in conjunction with the signal word
'DANGER' indicates an imminent danger. Failure to
observe this safety information will result in death or
severe injury.
DANGER – Serious damage to health / risk to life
This symbol in conjunction with the signal word
'DANGER' indicates an imminent electrical hazard.
Failure to observe this safety information will result in
death or severe injury.
WARNING – Bodily injury
This symbol in conjunction with the signal word
'WARNING' indicates a potentially dangerous situation.
Failure to observe this safety information may result in
death or severe injury.
WARNING – Bodily injury
This symbol in conjunction with the signal word
'WARNING' indicates a potential electrical hazard.
Failure to observe this safety information will result in
death or severe injury.
CAUTION – Minor injuries
This symbol in conjunction with the signal word
'CAUTION' indicates a potentially dangerous situation.
Failure to observe this safety information may result in
minor or moderate injury. The symbol may also be used
for property damage warnings.
NOTICE – Property damage
This symbol indicates a potentially damaging situation.
Failure to observe this safety information may result in
damage to or destruction of the product and / or other
system components.
IMPORTANT (NOTE)
This symbol indicates operator tips, particularly useful
information or important information about the product
or its further uses. The signal word 'IMPORTANT
(NOTE)' does not indicate a dangerous or harmful
situation.
1.2 Safety precautions
Be sure to read, understand and follow the instructions
contained within this manual before and during use of the
equipment. Failure to do so could result in bodily harm or
damage to the equipment.
WARNING – Bodily injury Installation, operation,
maintenance and servicing must be performed:
— by suitably trained personnel only
— in accordance with the information provided in
this manual
— in accordance with relevant local regulations
1.3 Potential safety hazards
1.3.1 Electrical – high voltage
The Aztec ADS430 EZCLEAN air compressor unit requires a
230 or 115 V AC mains supply to operate. A mains isolation
switch must be fitted in the supply to the unit.
1.3.2 Compressed air supply
The Aztec ADS430 EZCLEAN system generates compressed
air up to a pressure of 50.7 psi(g) / 3.5 bar(g) maximum.
— do not use compressed air for any other purpose than
that for which it is provided
— never direct a stream of compressed air towards your
body or the body of any other person
— when handling / connecting compressed air lines:
— the correct safety procedures must be observed
— suitable PPE must be worn (goggles / gloves / overalls)
1.3.3 Weight
The Aztec ADS430 EZCLEAN air compressor unit weighs
approximately 10.3 kg (22.6 lbs.). The unit must be lifted
only using appropriate lifting equipment / personnel and in
accordance with relevant Health & Safety procedures and
requirements.
1.4 Safety standards
This product has been designed to satisfy the requirements
of IEC61010-1:2010 3rd edition 'Safety Requirements for
Electrical Equipment for Measurement, Control and Laboratory
Use' and complies with US NEC 500, NIST and OSHA.
Aztec ADS430 EZCLEAN | Compressed air supply unit | OI/ADS430/EZCLN–EN Rev. B
3
Advertisement
Table of Contents
