Table of Contents
Advertisement
3.3 Pole-mounting
This procedure is for pole-mounting using the
optional pole-mounting kit (part no. ADS430197).
When choosing the mounting location, leave sufficient
space in front of the unit to open the door fully
(280 mm [11.0 in.]).
Dimensions in mm (in.)
330
(13.0)
395
(15.5)
205
(8.1)*
*Add 280 (11.0) when door open
Fig. 3.3 Pole-mounting
8
OI/ADS430/EZCLN–EN Rev. B | Aztec ADS430 EZCLEAN | Compressed air supply unit
Referring to Fig. 3.3:
1.
Fit the pole mounting plate
and secure using the M6 screws
2. Position the compressor unit
D
using the U-bolt
and M8 nuts / washers
IMPORTANT (NOTE)
It is not usually necessary to fit a second pole mounting
plate (and U-bolt) to the bottom of the enclosure but, if
necessary, an additional kit (ADS430197) is required.
A
to the compressor unit
C
(supplied).
B
on the pole and secure
E
(supplied).
50 (1.9) U-bolt
205 (8.1) + 25 (1.0)
42 (1.6) U-bolt
205 (8.1) + 21 (0.8)
420
(16.5)
B
Advertisement
Table of Contents
