Table of Contents
Advertisement
Model 35601A
Operation
©
10MHz Input: This input accepts the 10MHz Reference
Output from the -hp- 3585A.
(J\
Output to 3582A B Channel Input: This output is routed to
^
the -hp- 3582A B Input via a patch-panel below the -hp-
3582A.
(J)
Noise Input: This input accepts the Noise Output from the
^
-hp-3582A.
Q
AC Power Line Connector: Connects instrument to ac
mains. (See the Installation section for appropriate power
cable.)
Q
Line Voltage Selector Switches: These switches should be
^ ^ set to select the appropriate power line voltage range for
the mains available where the instrument is to be operated.
(See the Installation section of this manual for instructions
on setting these switches.)
Q
Fuse Holder: Holds ac power line fuse. (See the Installation
section for appropriate fuse size.)
(J\
HP-IB Address Selection Switches: Selects the desired HP-
IB address. (See the Installation section for instructions.)
(f)
IF Input: This input accepts the IF Output from the -hp-
w
3585A.
fi\
HP-IB Connector: Provides HP-IB control of the instrument;
w
accepts a standard HP-IB cable. (See the Installation sec
tion for instructions.)
(Jo) 10MHz Output: This output provides the 10MHz Reference
Output of the -hp-3585A after having been buffered by the
-hp-35601 A.
/ j j \
Output to 3582A A Channel Input: This output is routed to
^
the -hp- 3582A A Input via a patch-panel below the -hp-
3582A.
Figure 3-2. -hp- 35601A Rear Panel
3-3/3-4
Advertisement
Table of Contents
