The Acs800-04/U4; What This Chapter Contains - ABB ACS800-U4 Hardware Manual

The ACS800-04/U4

What this chapter contains

This chapter describes the construction and operating principle of the drive in short.
The ACS800-04/U4
The ACS800-04/U4 is an IP 00 drive module for controlling AC motors. It is to be
installed into a cabinet by the customer. The input cable terminals are located at the
top of the unit whereas the motor cable terminals are located at the left hand side of
the unit.
Fastening points
Motor cable terminals
Brake chopper and
intermediate circuit DC
bus terminals
PE terminal
Alternate output cable
terminals
Slots for cables going to the RMIO board in the RDCU unit. The cables are wound
on the top of the module.
Fastening bracket
Input cable terminals
Fastening points
Front cover
Three additional holes for fastening the
cable terminal plate to a lower position or for
connecting cable lugs
Pedestal
21
The ACS800-04/U4