Troubleshooting
6LJQDOUHODWHG V\PSWRPV RYHUYLHZ
Signal-related symptoms (overview)
This section describes symptoms related to the signal. The symptom may be too
much signal, too little signal, a noisy signal, or an incorrect signal. Signal-related
symptoms are generally observed during tuning but may also be observed during
data acquisition.
Error messages in autotune due to insufficient signal may vary.
The following symptoms are covered in more detail in this section:
• No or low reagent gas signal. See page 81.
• No or low PFDTD signal. See page 83.
• Excessive noise. See page 84.
• Low chromatographic signal abundance. See page 84.
• Low signal-to-noise ratio.
• Large peak at m/z 19. See page 85.
• Peak at m/z 32. See page 86.
78