Table of Contents
Advertisement
PACE Pressure Indicators User Manual
6.11 Installation and Ancillary Equipment Kit
Refer to the PACE1000 data sheet for details.
6.12 Return Goods/Material Procedure
If the unit requires calibration or is unserviceable return it to the nearest GE Service Centre
listed at www.gemeasurement.com
Contact the Service Department to obtain a Return Authorisation (Worldwide excluding USA).
In the USA obtain a Return Material Authorization [RMA].
Providing the following information on either a RGA or RMA:
•
Product (i.e. PACE1000)
•
Serial number
•
Details of defect/work to be undertaken
•
Calibration traceability requirements
•
Operating conditions
Safety Precautions
You must inform GE if the product has been in contact with any hazardous or toxic
substance.
The relevant COSHH or in the USA, MSDS, references and precautions to be taken when
handling.
Important notice
Service or calibration by unauthorized sources will affect the warranty and may not
guarantee further performance.
6.13 Packaging Procedure
1
The instrument should be at zero/ambient pressure.
2.
Switch off and isolate the electrical power supply to the instrument.
3.
Shut off the pneumatic pressure and vacuum supplies to the instrument.
4.
Remove the instrument from the equipment rack to access the rear panel.
5.
Disconnect the power supply cable and the pneumatic supply hose assemblies.
6.
Stow the power supply cable in the packaging below.
7.
Remove any pressure adaptors, diffusers and restrictors.
If available, use the original packing material. When using packing materials other than the
original, do the following:
8.
Fit protection to all the ports to prevent ingress of moisture and dirt.
Note: Use the original red plastic plugs or low tack masking tape.
9.
Wrap unit in polyethylene sheeting.
[EN] English
6 - 31
K0470 Revision A
Advertisement
Table of Contents
