Inserting/Removing The Scale Filter Insert; Storage; Troubleshooting - Silvercrest SWKS 2400 E1 Operating Instructions Manual

Inserting/removing the scale filter insert
GB
IE

Storage

Troubleshooting

10
1) Open the lid.
2) Hold the scale filter insert
upwards out of the holder.
3) Clean the scale filter insert
running water.
4) After cleaning, re-insert the scale filter insert
correctly in its holder.
NOTE
► If scale deposits have solidified in the scale filter insert
a water-vinegar solution with a ratio of 6:1 for a few hours. The scale de-
posits will dissolve. Rinse the scale filter insert
■ Allow the appliance to cool down completely before putting it into storage.
■ Wind the power cable around the cable winder
■ Store the appliance at a dry location.
Problem
The plug is not inserted into
a mains power socket.
The appliance is not
switched on.
The appliance
does not function.
The appliance is defective.
The appliance is over-
heated and the overheating
protection is active.
The kettle is not on the
The ON/OFF
base
switch does
not engage.
The appliance is defective.
by the tab and pull the scale filter insert
with a slightly moistened dishcloth under
. Ensure that it is sitting
with plenty of fresh water.
Cause
Insert the plug into a
mains power socket.
Switch the appliance on.
In this case, contact
Customer Services.
Allow the appliance to
cool down.
Place the kettle on the
. base
In this case, contact
Customer Services.
, place the filter in
under the base .
Remedy
.
SWKS 2400 E1