Workbench; Safety Recommendations; Checking Eudemon200 And Accessories - Huawei Quidway Eudemon 200 Installation Manual

Installation Manual
Quidway Eudemon 200 Firewall
Add a lightning arrester for power supply onto the front end of the power input in
order to protect the power supply from lightning strikes in a more effective way.
Add a special lightning protection facility at the input end of the signal cables in
order to protect the signal cables led to the outdoors, such as ISDN cable, and
E1/T1 cable, from lightning strikes in a more effective way.

2.1.5 Workbench

Following are the rules that you should observe when installing the equipment:
Leave enough clearance at the air intake vents and air exhausting vents to ensure
adequate ventilation of the equipment chassis.
Make sure that the workbench has a good ventilation system.
Make sure that the workbench is stable enough and can support the weight of the
equipment and the installation accessories.
Make sure that the workbench has been well-grounded.

2.2 Safety Recommendations

When reading this manual, you should pay adequate attention to the following symbol
and the contents beneath it.
Caution appears throughout this manual in procedures that, if performed
incorrectly, might harm you or damage the Eudemon200 firewall equipment.
When installing or working on a equipment, you are recommended to:
Keep the equipment far away from the heat sources and water/liquid.
Make sure that the equipment has been correctly grounded.
Wear ESD-preventive wrist strap in the installation and maintenance, make sure
that the strap has good skin-contact.
Do not hot swap the RPU of the equipment.
Do not plug/unplug cables if there is electricity.
Connect the cables to the ports appropriate to them. Above all, do not insert the
ISDN cable into a serial port.
Use laser cautions. Do not directly stare into the radiation aperture of the laser or
the fiber connector connected to it.
Adopt Uninterrupted Power Supply (UPS).

2.3 Checking Eudemon200 and Accessories

After having confirmed that the installation conditions comply with the requirements,
please open the packing cases of the equipment and check that the equipment and the
Chapter 2 Installation Preparation
2-3