Sanyo POA-MD13NET2 Owner's Manual page 147

Setting to control the equipment connected to the serial port from the
computer
Serial Control :Selects "External"
:Sets according to the com-
Port
puter specified port no. Do
not use port no. 10000*
:Sets according to the com-
Other Settings
munication condition of the
equipment
Setting to control the projector from the serial controller connected to
the serial pot
Serial Control :Selects "Projector"
Port :Not specified. Do not use
port no. 10000*
Other Settings :Sets according to the com-
munication condition of
serial controller
Setting to control the projector from the computer through the LAN
port
Serial Control :Not specified
Port :Not specified
Other Settings :Not specified
* The port no. of the computer is must be used with 10000.
*1 This product will restart automatically when "Port" or "Serial Control" is changed and it
takes about 40 seconds.
*2 The reserved port numbers are http (80), ftp (21), telnet (23), etc. The port no. 10000 is
reserved to control the projector through the LAN port.
There are 2 types of RS-232C serial cable, Normal(Straight) and Reverse(Cross) type. This
product provides with a serial port switching socket. Set this switch to proper side according
to the cable type. How to switch the serial port socket, see item "Serial Port Switch".(
Exclusive driver software for control of the external equipment is required. This product does
not provide any driver software. Please consult your local dealer.
2 .
.
2
the
Serial Port Setting
p.61)
59
Network Board
OWNER'S MANUAL