Table of Contents
Advertisement
500ML Lighting Control Console
HOTKEYS
1. General Hotkeys
[SHIFT] + [OFF] = Release all Cuelists, clear Programmer and reset all Fader values back to 100%
[OFF] + [CUELIST] = Release all Cuelists
[SHIFT] + Preset PoolItem = Copy Preset contents for all selected fixtures to programmer instead of linking to preset
Pressing the [BACKSPACE] Button for longer will clear the complete command line.
Whenever there is a keypad dialog shown on the touch screen display, the face-plate keypad may be used to enter
values. Most of the times you can also use the [+] or [-] key to increase or decrease the current value. This is
especially useful, if you would like to adjust a timecode-time framewise.
2. Programmer Hotkeys
[SHIFT] + [LOAD] = For all selected fixtures load the current output values to programmer.
[SHIFT] + [CLEAR] = Will revert back to the last programmer state (Unclear Programmer)
[SHIFT] + [LAST] = Will deselect all fixtures
[SHIFT] + [NEXT] = Will select all fixtures (of the current selection set, if applicable)
[LAST] + [NEXT] = Will select all fixtures (of the current selection set, if applicable)
[SHIFT] Will show fine values in programmer and allows for fine adjustment of parameters using the encoders.
Holding down the [FAN] Button automatically switches off the fan function as soon as the button is released.
Holding down the [CLEAR] hard key for longer will fully clear command line and programmer.
Pressing the [BACKSPACE] Button for longer will clear the complete command line.
3. Output Screen Hotkeys
[SHIFT] Button shows fine values in output screen.
4. Library Editor Hotkeys
[SHIFT] Button shows fine values for default/highlight/blackout values
5. External Keyboard Hotkeys
F9 = Make screen shot of internal monitor (needs USB Stick to be connected to desk)
F10 = Make screen shot of external monitor (needs USB Stick to be connected to desk)
QuickStart Guide
53
General Hotkeys
- Quick Links:
- Masters (Faders)
Hide quick links:
Advertisement
Table of Contents
