Introduction; General - Philips SOPHO SuperVisor 25 Engineer's Manual

1.

INTRODUCTION

1.1.

GENERAL

The SOPHO SuperVisor Model 25 and 35 (SV25 and SV35) are operator consoles which can
be applied for the complete range of SOPHO-S and SOPHO iS3000 series.
Model 25 has less functionality than model 35. Model 25 is equipped with an analogue interface
and an S bus interface. You can choose the interface which is required for your system. Model
0
35 is equipped with only an S
The functionality of model 25 is depends on the functionality which is available via the system
interface. Therefore, be aware of the fact that the available functionality on model 25 differs
for the two types of interfaces. In this document a distinction is made between model 25 on
the analogue interface and model 25 on the S
made:
- Model 25-S , if used with an S
0
- Model 25-A, if used with an analogue system interface.
Model 35 is equipped with only an S
In the table below an overview is given of the SuperVisor consoles in relation to the systems.
For the model 25-A the interface circuit in the system is also given in the table. For Model 25-
S and model 35 the interface in the system is always a DTX-I, a DLC-C/D/U or a DOC in
0
conjunction with a PNT1 (version 2).
bus interface.
0
bus interface. The following references are
0
bus system interface.
0
bus system interface.
0
3