Philips SOPHO SuperVisor 25 Engineer's Manual page 22

PR/SSW
200/205
200/205
300
300
300
300
735
735
735
735
740/8xx
740/8xx
740/8xx
740/8xx
Table 2-2 Relations between PR/SSW, HW interface and PMC package.
Choose then which one of the following sections is appropriate for your system. This depends
on the peripheral board used. Determine which circuit you want to use for the Supervisor.
The circuit to be used must be an even circuit (use the first circuit in an S
assumed that circuit 2 is used for the Supervisor. Note that only one B-channel (circuit) is used
for this purpose. Due to the power consumption of the Supervisor, the second B-channel
(circuit 3 in this case) of the same S
PROCEDURE: Projecting in SSW 200/205 and SSW 300
The SV25/35 may be connected to a DTX-I, a DLC-C/D/U or a DOC board. Execute the
following steps:
Actions
1. Check which row in
package." is applicable to your system and execute the action mentioned.in the "action"
column.
2. If connected to a DOC:
20
HW INTERFACE
DLC-C/D, DOC
DLC-C/D, DOC
DLC-C/D, DOC
DLC-C/D, DOC
DTX-I, DLC-U
DTX-I, DLC-U
DLC-C/D
DLC-C/D
DTX-I, DLC-U
DTX-I, DLC-U
DLC-C/D, DOC
DLC-C/D, DOC
DTX-I, DLC-U
DTX-I, DLC-U
bus cannot be used for other terminals.
0
Table 2-2 "Relations between PR/SSW, HW interface and PMC
PMC PACKAGE
> 205.10
205.10
> 300.31
300.31
> 300.22
300.22
> 144.6/244.6
144.6/244.6
> 144.6/244.5
144.6/244.5
PPU-741.4*)
> PPU-741 4*)
< PPU-741.4*)
PPU-741.4*)
ACTION
280E
no action
280E
no action
not possible
no action
1905
no action
not possible
no action
1905
no action
not possible
no action
bus). Here it is
0