Data Management; General - Philips SOPHO SuperVisor 25 Engineer's Manual

Busy uploading firmware ...
('zzz' = number of transmitted blocks)
'zzz'
Upload VPU data [Y/N]:
8. It is always required to upload all (nine) VPU data files also. Type 'Y'. Your screen will be
as follows:
Upload VPU data [Y/N]:Y
File name is VPUD01_1.DWL VPUD02_1.DWL VPUD09_1.DWL <CR>
Busy uploading VPU data ...
('zzz' = number of transmitted blocks)
'zzz'
Upload completed
9. Now the console is uploaded with the firmware and with the VPU data. (The VPU data
which is uploaded is for voice synthesis for call handling.)
4.4.

DATA MANAGEMENT

4.4.1. General

For data management a tool is available on floppy which enables you to handle directory, status
monitoring and speed dialling keys data. You can handle the data also on the console, but it
may be more convenient to prepare or handle the data on the PC and afterwards store it to
one or more consoles. It can be useful to retrieve data from a console and store it on a floppy
as backup. If the console must be replaced or if the number of consoles on one ISPBX has to
be expanded, you can easily store the backup data in the console. (In case of a power failure
there is no danger of data loss in the console because the data is stored in FEPROM.)
The following tool for data management is available on floppy:
- SVDR200.EXE.
You can start and execute the tool from floppy or hard disk. If you want to run it from hard
disk, copy the file from the floppy to a dedicated directory on the hard disk.
Note: Directory handling and speed dialling data handling is not possible for model 25. Handling
status monitoring data is only applicable for model 25 with S
Be aware of the fact that the SuperVisor model 25 with S
statuses of 100 extensions and that the SuperVisor model 35 is capable to monitor statuses of
600 extensions.
The procedure for using the tool is described in the following section.
36
bus interface.
0
bus is capable to monitor the
0