Data Management Procedure - Philips SOPHO SuperVisor 25 Engineer's Manual

4.4.2.

Data Management Procedure

PROCEDURE: Data Management Procedure
To retrieve, handle and/or upload the directory / speed dialling / status monitoring data
execute the following steps:
Actions
1. Be sure that the upload tool 'SVDR200.EXE' is on the floppy, or installed on the hard disk.
2. If you start the tool for the first time, check that there is no file with the name
'SFSV35DM.INI'. If so delete this file. It will be generated again when you startup the tool.
In this file the communication port settings are laid down for the communication port.
When the tool creates this file itself, the default settings will be COM1 and 9600 bit/s.
If the file already exists and you are sure that the settings in this file are correct, you don't
have to delete it.
3. If not yet done, connect a one-to-one V.24 cable between the Supervisor and the COM1
port of the PC.
4. Prepare console by pressing the 'menu key' as depicted here. In the soft key menu press
the button which is under 'comm' on the display. (If required consult
a total overview of the soft key menu.)
5. Select 'P-Dial' and bit rate 9600 bit/s. Using a higher communication speed (19200 bit/s)
may result in data errors!!! Press the button which is under 'Return' on the display. Now
your Supervisor is ready to except data from the PC.
6. On the PC, go to the directory in which the tool is installed and start the tool by entering:
SVDR200<CR>
7. The following text is displayed on the screen:
Directory PC tool at COM1 9600
1 - Retrieve data from SuperVisor
2 - Edit data
3 - Store data into SuperVisor
4 - Change settings
5 - Exit
A . "DIAGRAMS" for
37