Mounting/Extending; Installing The Device - Siemens Simatic Operating Instructions Manual

Mounting/Extending

6.1

Installing the device

The PN/CAN LINK can be mounted to a 35 mm standard mounting rail according to
DIN EN 60715 or installed on a control panel.
Information on the selection of the location of use as well as reliable mounting positions and
minimum clearances is available in the section Installation location (Page 58).
Mounting on a standard mounting rail
Proceed as follows:
1. Mount the PN/CAN LINK on the mounting rail.
2. Swivel the PN/CAN LINK backwards until it engages audibly.
Figure 6-1
NOTICE
If the device is not installed on a control panel, the mounting sliders (see figure Control
panel mounting item
Otherwise the mounting sliders may warp if they are exposed to hot and humid ambient
conditions for a long time.
SIMATIC PN/CAN LINK
Operating Instructions, 03/2018, A5E39895388-AB
PN/CAN LINK DIN rail mounting
①
) must always be in the default positions set at the factory.
6
63