Siemens Simatic Operating Instructions Manual page 90

Configuring / programming
9.3 Configuring CAN transparent
3. Assign the parameters of the PROFINET interface of the PN/CAN LINK
the configuration of your PROFINET network.
Figure 9-14
Selecting the CAN operating mode of the PN/CAN LINK
The CAN operating mode is selected using the "Set operating mode" drop-down list with the
following selection options:
● CANopen manager
● CANopen slave
● CAN transparent
Figure 9-15
1. Select the "CAN transparent" operating mode.
After selection of the operating mode the parameters associated with the selected mode
can be set. All settings for the "CAN transparent" module of the PN/CAN LINK are made
in slot 1.
88
TIA Portal: Devices & networks
Selecting the CAN operating mode
SIMATIC PN/CAN LINK
Operating Instructions, 03/2018, A5E39895388-AB
③
according to