Turning On The Server - NEC Express5800 Series User Manual
Hide thumbs
Also See for Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Pressing the POWER switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1. Turn on the peripheral devices and display unit.
2. If STATUS LED1, 2 are lighting green or amber, wait until it goes off.
3. Press the POWER switch at the front of the server.
The POWER LED is turned on green and after a while, logo appears on the display.
While logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware.
For details, see Chapter 3 (1.1 POST).
Tips
Wait for at least 30 seconds before turning on the server after turning it off.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Important
Do not connect or disconnect USB device while POST is running.
Express5800/T120g User's Guide
1. Turning on the Server
POWER switch
POWER LED
147
Advertisement
Table of Contents
