Chapter 2 Preparations
1.13.2 Removal
Remove optical disk drive in the following procedure.
1. See steps 1 to 5 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Remove the blank cover from Expansion Bay 1.
If the Expansion Bay 1 contains 5.25-inch device, remove the device.
3. Push the latch on connector of optical disk drive to unlock the connector, then disconnect the cable from
optical disk drive.
4. Move the lever of bracket located at lower right corner of optical disk drive bay to the direction shown by
(1) in the figure and then pull it forward shown by (2) to remove the bracket and optical disk drive from
the chassis.
5. Remove the bracket from optical disk drive, and mount the bracket to the chassis.
Express5800/T120g User's Guide
1. Installing Internal Optional Devices
97