Names And Functions Of Parts; Front View - NEC Express5800 Series User Manual

Chapter 1 General Description
4.

Names and Functions of Parts

This section describes the names of the server parts.
4.1

Front View

(2)
(1)
(1) Front Bezel
A cover to protect the front of the server. This cover can be
locked with the provided Bezel Lock Key.
(2) Key Slot
A slot for Bezel Lock Key that is used to lock Front Bezel.
(3) Stabilizers
Stabilizers for supporting the server.
(4) LINK/ACT LED
LEDs for showing the status of accessing to the network.
(
→See page 34)
The LED of (4)-1 means LAN1 and (4)-2 means LAN2.
(5) Power Capping LED
An LED for showing the power capping status.
(→See page 34)
24
(6) STATUS LED 1, 2
An LED for showing the server status. It lights green when
the server is operating normally. This LED flashes green
when a degeneration is detected in redundant hardware
configuration. If a failure is detected, it turns on or flashes
amber. (→See page 32)
(7) POWER LED
An LED for showing the power status. This LED lights
green when the power is on. This LED lights amber when
power cord is connected to power outlet until the system
becomes ready to power-on.
(8) POWER Switch
A switch for turning on/off the server. Press once to turn on
the server. POWER LED lights when it is on. Press it again
to turn off the server. Hold down the switch for four seconds
or more to forcibly turn off the server.
Express5800/T120g User's Guide
4. Names and Functions of Parts
(5) (6)
(4)-1 (7) (8)
(3)
(→
See page
32)