Names And Functions Of Parts; Front View - NEC E120e-M User Manual

Chapter 1 General Description
4.

Names and Functions of Parts

This section describes the names of the server parts.
4.1

Front View

(1)
STATUS LED
This LED indicates the server status. (→ 4.6.2 )
(2) 2.5-inch hard disk drive bay
The bay where HDD are installed. All bays include
Dummy Trays at shipment.
(3)
DISK LED
The LED provided for each HDD.
This LED indicates hard disk drive status.
→ 4.6.4
( )
(4)
Pull-out Tab
A label indicating the part number and serial number
of the server is located on Pull-out Tab.
(5)
USB connectors (front)
These connectors are used to connect devices that
support the USB interface.
(6)
BMC RESET Switch
The switch to reset BMC of this server. Use the
switch only
EXPRESSSCOPE Engine 3 (BMC).
To use this switch, press it at least five seconds.
32
(3)
when there is a problem
Note Hard disk drive number depends on your OS.
Express5800/E120e-M User's Guide
(2) (4)
(1)
(7)
DUMP Switch (NMI)
When DUMP Switch is pressed, memory dump is
performed.
(8)
Unit ID (UID) Switch/LED
The switch to turn on and off UID LED.
Pressing the switch once turns on UID LED and
pressing again turns off the LED.
Commands from the software also cause it to turn on
or flash..(→ 4.6.3 )
(9)
POWER Switch/LED
The switch to turn the server on and off. Press once to
turn on the server. POWER LED lights when it is on.
Press it again to turn off the server. Hold down the
switch for 4 seconds or longer to forcibly turn off the
server.
(→ 4.6.1 )
(10)
Display connector
Connect a display unit.
with
4. Names and Functions of Parts
(10)
(5)
(6)
(7) (8) (9)