Table of Contents
Advertisement
Chapter 2 Preparations
(2) When using the optional RAID controller (N8103-168)
For details, refer to the manual that comes with optional RAID Controller (N8103-168).
Take the following procedure to install RAID Controller (N8103-168).
1. Refer to steps 1 to 3 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Remove the two screws from RAID
Controller, and remove PCI bracket.
3. Remove the two screws from bracket of additional PCI riser kit, and remove the bracket.
•
You must avoid ESD damage to work with the procedure below. For details, refer
Important
to Chapter 2 (1.2 Anti-static Measures).
•
Do not let the system enter hibernation or standby mode while the RAID System
is configured.
Note
•
When installing an optional RAID Controller, run the BIOS Setup utility, select PCI
Configuration → PCI Device Controller and Option ROM Settings from the
Advanced menu, and then make sure that the parameter of PCI Slot xx Option ROM
(xx is PCI slot number) is set to Enabled.
•
When connecting a RAID Controller, set the boot priority to 8th or higher in the Boot
menu of the BIOS Setup utility. If the setting is 9th or lower, the configuration menu for
RAID Controllers cannot be launched.
Screw
Express5800/E120e-M User's Guide
1. Installing Internal Optional Devices
PCI bracket
Bracket
Screw
Screw
RAID Controller
75
Advertisement
Table of Contents
