Cases That Require Configuration - NEC E120e-M User Manual

Chapter 3 Setup
2.4

Cases that Require Configuration

Only if a case applies to any of following cases, use the SETUP utility to change a parameter which was
configured as factory setting. A list of SETUP parameters and factory settings are described in Chapter 2 (1.
System BIOS) in "Maintenance Guide".
Category
Basic Change date and time
Enable NumLock at power-on
Hide the logo during POST
Memory Add or change DIMM
Optional Disable Option ROM Scan of
board installed option board
Boot Change the boot order of
devices
Use remote power on function
(via modem)
Use remote power on function
(via RTC alarm)
Use console redirection
feature
Security Set a password
Restrict bootup by entering
password
UPS When the server is supplied
Powerlink with power from UPS, always
turn on the power.
If it is turned off by using
POWER switch, leave it OFF
even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
Description
Main → System Date
Main → System Time
Boot → Bootup Numlock State → On
Boot → Quite Boot → Disabled
Advanced → Memory Configuration →
Memory Retest → Yes
Advanced → PCI Configuration → PCI
Device Controller and Option ROM
Settings → PCIXX Slot Option ROM →
Enabled
Boot → Boot Option Priorities →
Change the boot priority
Advanced → Advanced Chipset
Configuration → Wake On Ring →
Enabled
Advanced → Advanced Chipset
Configuration → Wake On RTC Alarm
→ Enabled
Advanced → Serial Port Configuration
→ Console Redirection Setting →
Change respective setting.
Security → Administrator Password →
Enter a password
Security → User Password → Enter a
password
Security → Password on Boot →
Enabled
Server → Power Control Configuration
→ AC-LINK → Power On
Server → Power Control
Configuration → AC-LINK → Last State
Server → Power Control Configuration
→ AC-LINK → Stay off
Express5800/E120e-M User's Guide
To be changed
2. System BIOS Setup
Remark
Configurable on OS
By pressing the <Esc> key,
prevent the display of the
logo.
After rebooting, Memory
Retest changes No
automatically.
XX is PCI slot number of the
option board
When you use
EXPRESSBUILDER, set
CD/DVD to the highest
priority.
If password is set, a
message to enter password
is displayed at next time
SETUP is launched.
Can be selected when
password is set.
109