Table of Contents
Advertisement
Chapter 3 Setup
2.4
Cases that Require Configuration
Only if a case applies to any of following cases, use the SETUP utility to change a parameter which was
configured as factory setting. Other than cases described below, do not change the settings. A list of SETUP
parameters and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category
Basic
Change date and time
On/Off NumLock on power ON
On/Off the function to display
the NEC logo during POST
Optional
Install RAID Controller board
board
Boot
Change the boot order of
devices
Use remote power on function
(from modem)
Use remote power on function
(from RTC alarm)
Control from HW console
terminal
Security
Set a password
UPS
When the server is supplied
Powerlink
with power from UPS, always
turn on the power.
If the server is turned off by
using POWER switch, leave it
OFF even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
Description
Main → System Date
Main → System Time
Boot → Bootup Numlock State
Boot → Quite Boot → Disabled
Advanced → PCI Configuration → PCI
Slot n Option ROM → Enabled
Boot → Boot Option Priorities →
Change the boot priority
Advanced → Advanced Chipset
Configuration → Wake On Ring →
Enabled
Advanced → Advanced Chipset
Configuration → Wake On RTC Alarm
→ Enabled
Advanced → Serial Port
Configuration → Change respective
setting.
Security → Administrator Password
→ Enter a password
(Set a password for Administrator first
and then User)
Server → AC-LINK → Power On
Server → AC-LINK → Last State
Server → AC-LINK → Stay off
Express5800/B120e User's Guide
To be changed
Configurable on OS
Pressing the <Esc> key can
hide the logo.
n is PCI slot number of the
RAID Controller
There are two types of
password; Administrator and
User.
Settings for User password
is limited compared to for
Administrator.
2. BIOS Setup Utility (SETUP)
Remark
91
Advertisement
Table of Contents
