Table of Contents
Advertisement
Chapter 3 Setup
3.2
EXPRESSSCOPE ENGINE 3 Network Configuration
The network configuration of management LAN of EXPRESSSCOPE Engine 3 is obtained automatically from
the Enclosure Manager which has DHCP server function. For detailed information on DHCP server of EM card,
refer to EM Card User's Guide or Blade Enclosure User's Guide. By the factory default, DHCP is set to
Enabled.
If DHCP is set to Disabled and you want to use the management LAN of EXPRESSSCOPE Engine 3, follow
steps below to configure the network.
1.
Run POST following Chapter 3 (1.5.1 POST Execution Flow). Wait until the following message appears
on the lower left of the screen.
Press <F2> SETUP, <F3> Internal flash memory, <F4> ROM Utility, <F12> Network
2.
If you press the <F4> key at this time, ROM utility starts upon completion of POST.
You can also press the <F4> key while the NEC logo is being displayed to open the Off-line TOOL MENU
screen.
3.
The keyboard selection screen appears. Select your keyboard type.
After that, the Off-line TOOL MENU screen appears. On this screen, specify the network settings for
EXPRESSSCOPE Engine 3.
4.
When the Off-line TOOL MENU appears, select BMC Configuration, BMC Configuration, Network,
and then Property.
94
Express5800/B120e User's Guide
3. EXPRESSSCOPE ENGINE 3
Advertisement
Table of Contents
