Expressscope Engine 3 Network Configuration - NEC Express5800 Series User Manual
Express server
Hide thumbs
Also See for Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
3.2
EXPRESSSCOPE Engine 3 Network Configuration
Follow the steps below to use EXPRESSSCOPE Engine 3 with a web browser.
1. Run POST following Chapter 3 (1.1.1 POST sequence). Wait until the following message appears on the
lower left of the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
2. Press <F4> key while the message is being displayed to launch ROM Utility.
3. Choose your keyboard type on Keyboard Selection screen.
4. On Off-line TOOL MENU, choose Server Configuration Utility → EXPRESSSCOPE Engine 3 →
Configuration → Network → IPv4 Property or IPv6 Property.
128
Express5800/R120g-1E User's Guide
3. EXPRESSSCOPE Engine 3
Advertisement
Table of Contents
