Removal - NEC Express5800 Series User Manual

Chapter 2 Preparations
6. Secure the PCI card with the screw removed in step 4.
7. Connect the PCI riser card to the slot on
motherboard and secure the card with two
screws removed in step 2.
Position the terminal part of the PCI riser
card to the slot on the motherboard and
insert it.
8. Continue to install or remove internal options, mount and connect the server, and turn it on.
9. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, see Chapter 3 (1. POST Error Message) in "Maintenance Guide".
10. Run the configuration utility of the card to set up the board as needed.
For details, see the manual that comes with the card. If a PCI card including RAID controller and LAN
adapter which connects to any bootable device is added, the boot priority might be changed to
the default setting. In that case, configure the boot priority in Boot menu of BIOS Setup Utility. For
details, see Chapter 2 (1. System BIOS) in "Maintenance Guide".
1.11.4

Removal

To remove a PCI card, reverse the installation procedure.
Run SETUP and change boot order in Boot menu as needed. See Chapter 2 (1. System BIOS) in "Maintenance
Guide" for how to specify it.
If using the server with the PCI card removed, attach the blank cover that comes with the riser card.
88
PCIe #1D Low Profile side
Tips
To connect a PCI card to the connector on motherboard with cable, connect a
cable to PCI card before installing PCI riser card.
Express5800/R120g-1E User's Guide
1. Installing Internal Options
PCIe #1C Full Height side