Chapter 2 Preparations
9. Disconnect SAS cable from SAS connector on
motherboard, and connect that cable to
PORT(0-3) connector on RAID Controller.
For N8103-168, the location of connector
PORT(0-3) differs from that of
N8103-172/173/174, thus the longer cable
length is required. Extend the excess length
portion before connecting the cable. See the
figure below for excess length portion.
Remove the fan duct before extending the excess length
portion. Lift the fan duct while pushing it toward the
direction indicated by an arrow.
Left server module
78
Use only one cable for connecting to PORT(0-3)
Right server module
Fan duct
Remove the cable tie to extend
the excess length portion, and
fasten it again with cable tie.
Express5800/E120e-M User's Guide
1. Installing Internal Optional Devices
SAS cable
Port0-3 connector
FBU cable