Post Error Messages - NEC E120e-M User Manual

Chapter 3 Setup
<F2> key:
<F4> key:
<F12> key: Boot from network.
6. If a controller which has its dedicated BIOS such as a RAID Controller board is installed, a message that
prompts you to start the dedicated utility to set each board is displayed.
Example: If an optional RAID Controller is installed
Press <Ctrl> <H> for Web BIOS
The utility starts by pressing <Ctrl> + <H> keys.
For details on the utility, refer to the manual supplied with each optional board.
Depending on the configuration, the message "Press Any Key" might appear to prompt a key entry. This
is a behavior of the BIOS of the optional board. Continue to operate after checking the manual of the
optional board.
7. The OS starts when POST is completed.

1.1.2 POST error messages

When POST detects an error, it displays an error message on the screen or beeps for some errors. For
descriptions of error messages, causes, and countermeasures, refer to Chapter 3 (1. POST Error Message) in
"Maintenance Guide".
Run BIOS Setup Utility (SETUP). For information on the SETUP, refer to Chapter 2 (1.
System BIOS) in "Maintenance Guide".
Run Offline Tools. For information on Offline Tools, refer to Chapter 1 (9. Offline Tools) in
"Maintenance Guide".
Note Take notes on the indication displayed on display unit before consulting with your sales
representative. Alarm messages are useful information for maintenance.
Express5800/E120e-M User's Guide
1. Turning on the Server
105