Post Error Messages - NEC Express5800 Series User Manual

Chapter 3 Setup
3. POST displays the result of memory test, CPU status, and other messages.
4. After a while, the following message is displayed on the screen.
Press <F2> to enter setup, <F3> Internal Flash Memory, <F10> Display Boot Menu,
<F12> Force Network Boot
You can call the functions below upon completion of POST by pressing the function key.
<F2> key:
<F3> key:
<F10> key: Boot the boot menu.
<F12> key: Boot from network.
5. If you set a password in BIOS Setup Utility, the password entry appears upon successful completion of
POST.
Three incorrect password entries disable the server to boot. In such a case, turn off the power, wait at
least ten seconds, and then turn on the server.
6. The OS starts after POST is completed.

POST error messages

If POST detects an error, an error message is displayed on the screen or beeps are sounded. Write down
the error message for future use. For details, see "Maintenance Guide".
Tips
The value of memory capacity shown in the message may be smaller than the
actual physical memory depending on the hardware configuration. This applies to
the information in SETUP and system information of the operating system
Run BIOS Setup Utility (SETUP). For details, see Chapter 3 (2. BIOS Setup Utility (SETUP)).
Run EXPRESSBUILDER from Internal Flash Memory. For details, see Chapter 3 (4.
EXPRESSBUILDER).
Note
If bootable CD/DVD is inserted into optical disk drive, the system starts from
CD/DVD even if <F3> key is pressed.
Important
Do not set a password before OS is installed.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Turning on the Server
115