NEC Express5800 Series User Manual page 72

Chapter 2 Preparations
② Make sure lock plate insert into HDD cage slits
near the "!" icon in triangle mark. (Total 2
places shown in the figure.)
③ Make sure lock spring on chassis had fix lock
plate securely.
Update the system configuration information by following procedure.
1) Connect the AC cord to the server, then push the power switch to power on.
2) If POST screen is indicated, press F2 key of the keyboard and enter BIOS setup screen.
3) The POWER switch is pressed and the power supply of the server is turned off.
4) Remove the AC cord from the server, and leave the AC power of the server off around 30 seconds.
5) Connect the AC cord to the server again, and push POWER switch in order to power on the server.
72
Important
Make sure to insert the lock plate into the groove of the chassis correctly. Incorrect
installation causes the removal of the side cover to be impossible.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices