Chapter 2 Preparations
1.4
Removing the Front Bezel
Remove the front bezel by using the following procedure.
1.
See the steps 1 to 3 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
Remove the screw.
3.
Place the server in the direction shown in the figure.
① Push the tab on the upper side of the front bezel in
the direction of the figure.
② Pull the handle to the left side of the front bezel in
the direction shown, two hooks inside of bezel
could be release.
4. After unlocked two hooks inside of the front bezel, pull
the handle of the front bezel in the direction shown in the
figure (toward to user), the front bezel could remove from
the chassis.
Important
If you pull the front bezel forward too much, you will break the front bezel.
Gently slide it to prevent damaging the equipment.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
①
②
37