Rear View - NEC Express5800 Series User Manual

Chapter 1 General Description
4.2

Rear View

5 4
7-(1)
6-(1)
6-(2)
7-(2)
8
1 AC Inlet
A socket for connecting a power cord.
2 PCI Slots
Slots for installing PCI cards.
3 Chassis Lock Tab
A tab for locking the side cover.
4 Serial Port 1 (COM 1) Connector
A connector for connecting serial interface devices.
This cannot directly connect to a network line. If the
optional N8117-01A Additional RS232C Connector Kit is
connected, the connector of N8117-01A is assigned as
the serial port 2.
5 Display Connector
A connector for connecting a display
6 USB Connectors
6-(1) Connectors for connecting USB 3.1 interface
devices.
6-(2) Connectors for connecting USB 3.0 interface
devices.
Important
Do not install PSU of N8100-2682F/2808F in N8100-2810F.
Do not install PSU of N8100-2810F in N8100-2682F/2808F.
22
1
10 9
PCI#1
PCI#2
PCI#3
PCI#4
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1
11-(2)
2
3
7 LAN Connectors
7-(1) LAN1 connector.
7-(2) LAN2 connector.
Connectors for connecting to a network (1000BASE-
T/100BASE-TX /10BASE-T).
If Shared BMC LAN feature is enabled in "ROM Utility"
change to in "BIOS Setup Menu", LAN1 connector can
also be used as the management LAN connector. Sharing
port is not recommended from the point of performance
and security.
Note: Shared BMC LAN only support to LAN1 connector,
original LAN1 and Management LAN MAC address
will be invalid.
8 Management LAN Connector
A LAN connector (1000BASE-T/100BASE-TX/10BASE-T)
for connecting BMC Management Console. This
connector cannot be used as a normal LAN port. This port
cannot be used when Shared BMC LAN feature is used.
9 LINK/ACT LED (green)
LEDs for showing the access status of LAN
10 SPEED LED (green/amber)
LEDs for showing the transfer speed of LAN ports
11 PSU Unit
11-(1) PSU Unit 1 (Redundant power supply model)
11-(2) PSU Unit 2 (Redundant power supply model)
4. Names and Functions of Parts
11-(1)