Removal - NEC Express5800 Series User Manual

Chapter 2 Preparations
Connecting to a RAID Controller
1. Connect another connector of the flash backup unit control cable to the RAID controller. Check
the marker of the connector and connect the cable straight into the connector. Be careful not to
press it in at an angle when connecting.
Position of the connector
Connect the cable to the connector shown in the figure below.
2. Install the RAID controller into the PCI slot #4 and fix it in place. Be careful not to disconnect the
cable.
3. Connect the cables and components that you removed.

Removal

To remove the flash backup unit, reverse the installation procedure.
Tips
For the position of the connector of N8103-206/207/208, refer to the manual
attached to N8103-206/207/208.
Black Marker
RAID Controller
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
RAID Controller
51