Notes - NEC Express5800 Series User Manual

Chapter 2 Preparations

Notes

Read the following notes when installing or removing a PCI card.

Do not touch the terminals of cards and the leads of electronic components with your bare hand.
Fingerprints and dust left on them cause the server to malfunction due to a connection failure or
damage to the leads.

The search order for PCI bus slot on boot is as follows.
Slot 3  Slot 4  Slot 2  Slot 1

The PCI devices of the same type (including onboard PCI device) may be recognized in different order
from that described above, depending on OS or RAID System BIOS utility. Check the slot location of
PCI device by PCI bus number, device number and function number shown in the table below.
Standard LAN1
Standard LAN2
Slot 1
Slot 2
Slot 3
Slot 4

Set Disabled for the optional ROM of a PCI devices not to be booted by using the BIOS Setup utility.

If an additional bootable PCI card (such as a RAID Controller, SAS controller, or LAN card) is installed,
the boot priority may change. After the installation, set the boot priority in the Boot menu of the BIOS
Setup utility.
PCI device PCI bus number
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
Device number
80h 0
80h 0

A0h

90h

50h

70h
1. Installing Internal Optional Devices
Function number
0
1




53