Connecting Cables; Internal Interface Cables - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.16

Connecting Cables

This section shows an example of internal device cable connection.

Internal interface cables

This section describes the connection of internal interface cables.
(1) Connecting hard disk drives
This section describes how to connect additional hard disk drives.
(a) Using 3.5-inch hard disk drives
Connect the cables as in the following figure when adding 3.5-inch hard disk drives. Install the hard disk
drives in order from the left side.
Connect the first Hard Disk Drive to SATA0, the second to SATA1.

Connecting to the miniSAS HD connector on the motherboard
An internal SATA cable provided with the N8154-136 3.5-inch non-Hot Plug Drive Cage Kit is required.
You can use the controller on the motherboard to build a RAID system (SW RAID). For more information,
see Chapter 2 (5. RAID System Configuration) in "Maintenance Guide".
90
Tips
The figure shown here primarily describes connections. For more information about
the connectors on the motherboard, see Chapter 1 (4.4 Motherboard).
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
（N8154-136）