Connecting Cables; Internal Interface Cables - NEC N8100-1983F User Manual

Chapter 2 Preparations
1.15

Connecting Cables

This section shows an example of internal device cable connection.

1.15.1 Internal interface cables

This section describes the connection of internal interface cables.
(1) Connecting hard disk drives
This section describes how to connect additional hard disk drives.
(a) In case of 3.5-inch hard disk drive installed
Connect the cables as in the following figure when adding 3.5-inch hard disk drives. Install the hard disk
drives in order from the left side.
Connect the first Hard Disk Drive to SATA0, the second to SATA1.
•
Connecting to the miniSAS connector on the motherboard
A dedicated cable (K410-278(00)) is required.
Power
supply unit
Motherboard
SATA cable (for the optical disk drive)
Internal SATA cable (K410-278 (00))
You can use the controller on the motherboard to build a RAID system. For more information, see Chapter
2 (4. RAID System Configuration) in "Maintenance Guide".
90
Tips
The figure shown here primarily describes connections. For more information
about the connectors on the motherboard, see Chapter 1 (4.4 Motherboard).
SATA4
MINI SAS1
Slot 0: First Hard Disk Drive
Slot 1: Second Hard Disk Drive
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
Optical disk drive
3.5-inch HDD cage
(N8154-65F)