Table of Contents
Advertisement
Chapter 2 Preparations
•
Connecting a RAID controller (N8103-149) and an extra 2.5-inch HDD cage (N8154-56F)
When a RAID controller (N8103-149) is installed and an extra 2.5-inch HDD cage (N8154-56F) is
connected, dedicated cables (K410-277(00) and K410-287(00)) are required. Do not use the cable that
comes with the extra 2.5-inch HDD cage (N8154-56F).
Install the hard disk drives sequentially starting from the leftmost slot when viewed from the front.
(4 to 7)
RAID controller
(
•
About RAID LED cables
The DISK access LED on the front of the equipment shows the access status of hard disk drives that are
connected to a RAID controller. To display this status, connect the LED cable that comes with the optional
cable K410-277(00).
Connect the LED connector on the motherboard to the connector on the RAID controller.
See the figures below and connect the LED cable to the LED connector of the motherboard.
Motherboard
92
Power
supply unit
Motherboard
HDD LED1
SATA4
(0 to 3)
N8103-149/151
)
Slot 1: Second Hard Disk Drive
SATA cable (for the optical disk drive)
Internal SATA cable (K410-277 (00))
RAID LED cable (included with K410-277 (00))
Battery cable (included with the extra battery)
Internal SAS/SATA cable (K410-287 (00))
LED connector
Express5800/T110f-S User's Guide
Extra 2.5-inch HDD cage
(N8154-56F)
Slot 4: Third Hard Disk Drive
Slot 5: Fourth Hard Disk Drive
I-SAS5
I-SAS4
Optical disk drive
Extra battery
(N8103-155)
3.5-inch HDD cage
(N8154-65F)
Slot 0: First Hard Disk Drive
To the motherboard side
1. Installing Internal Optional Devices
Advertisement
Table of Contents
