Table of Contents
Advertisement
Chapter 2 Preparations
Install a 2.5-inch HDD cage in the server by using the following procedure.
1.
See Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
To remove the side cover and the front bezel, see Chapter 2 (1.4 Removing the Side Cover and 1.5
Removing the Front Bezel).
3.
Set the jumper for the backplane board installed in
the HDD cage. The jumper setting when the
onboard SATA controller (LSI Embedded
MegaRAID) is used differs from that when the
optional RAID controller is used. For details, see
Chapter 2 (1.9 Use of Internal Hard Disk Drives in
the RAID System).
4.
Mount the rollers that come with the HDD cage on
the holes inside the HDD bay (10 places).
5.
Insert the HDD cage into the HDD bay. The "C side"
must face upward. Do not push the HDD cage to the
end for connecting cables later.
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
81
Advertisement
Table of Contents
