NEC Express5800 Series User Manual page 71

Chapter 2 Preparations
Install a 2.5-inch HDD cage in the server by using the following procedure.
See Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
To remove the side cover and the front bezel, see Chapter 2 (1.3 Removing the Side Cover and 1.4
Removing the Front Bezel).
Mount the rollers that come with the HDD cage on
the holes inside the HDD bay (10 places).
Insert the HDD cage into the HDD bay. The "C side"
must face upward. Do not push the HDD cage to the
end for connecting cables later.
Connect the interface cable and power cable to the HDD cage. Use the interface cable that
comes with the HDD cage. Use the power cable connected to the motherboard in advance. For
details of cable connection, see Chapter 2 (1.16.1 Internal interface cables) described later.
Push the HDD cage into HDD bay to the location
where Triangle marks matched shown in the figure.
Install lock plate
① Insert one side of the lock plate into the slit of
the chassis. Push the lock plate in the direction
shown by the arrow to lock the HDD cage.
Express5800/T110j-S, T110j-S (2nd-Gen) User's Guide
1. Installing Internal Optional Devices
71