Deleting A Tool - Siemens SINUMERIK 840D sl Operating Manual

6.5.3

Deleting a tool

Tools that are no longer in use can be deleted from the tool list for a clearer overview.
Procedure
Multiple load points - tool in magazine location
If you have configured several loading points for a magazine, then the "Loading Point
Selection" window appears after pressing the "Delete tool" softkey.
Select the required load point and press the "OK" softkey to unload and delete the tool.
HMI sl Universal
Operating Manual, 01/2008, 6FC5398-6AP10-2BA0
7. Repeat this process if you wish to create more tool edge offset data.
8. Position the cursor on the cutting edge that you want to delete and
press the "Delete cutting edge" softkey.
The data set is deleted from the list. The first tool cutting edge cannot
be deleted.
1. Select the "Parameter" operating area.
2. Press the "Tool list" softkey.
3. Place the cursor on the tool that you would like to delete.
4. Press the "Delete tool" softkey.
A safety prompt is displayed.
5. Press the "OK" softkey if you really want to delete the tool.
Use this softkey to delete the tool.
If the tool is in a magazine location, it is unloaded and then deleted.
Tool management
6.5 Tool list
161