Configuring Tool Management; Tool Management With/Without Magazine Management - Siemens SINUMERIK 840D sl Commissioning Manual

Configuring tool management

13.1

Tool management with/without magazine management

Setting without magazine management
Make the following settings if you are commissioning the tool management without NC
magazine management:
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK = 02H
Bit 1
MD20310 $MC_TOOL_MANAGEMENT_MASK = 02H
Bit 1
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER = 0FH
Identifying tool data change for HMI
Bit 0
Bit 1
Bit 2
Bit 3
MD28450 $MC_MM_TOOL_DATA_CHG_BUFF_SIZE = 100
HMI sl (IM9)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
Provide monitoring data.
Tool management monitoring functions active.
Functions for monitoring tools (tool life and workpiece count) are enabled.
Value changes to the tool status ($TC_TP8) are taken into account in
toolCounterC.
Value changes to the remaining tool count ($TC_MOP4) are taken into account in
toolCounterC.
Value changes to the tool data are taken into account in the tool data update
service.
Value changes to the magazine data are taken into account in the update
service.
Buffer for tool data changes (DRAM)
For every first channel of a TOA. The magazine must also be configured in the
NC and PLC.
13
81