Siemens SINUMERIK 840D sl Commissioning Manual page 88

Configuring tool management
13.1 Tool management with/without magazine management
MD19320 $ON_TECHNO_FUNCTION_MASK =2000000H
Bit 25
Setting with magazine management
Make the following settings if you are commissioning the tool management with NC
magazine management:
MD18080 $MN_MM_TOOL_MANAGEMENT_MASK = 03H
Bit 0
Bit 1
MD20310 $MC_TOOL_MANAGEMENT_MASK = 03H
Bit 0
Bit 1
MD17530 $MN_TOOL_DATA_CHANGE_COUNTER = 0FH
Identifying tool data change for HMI sl
Bit 0
Bit 1
Bit 2
Bit 3
MD28450 $MC_MM_TOOL_DATA_CHG_BUFF_SIZE = 100
82
The channel-specific machine data
MD20310 $MC_TOOL_MANAGEMENT_MASK; Bit 1 is enabled.
Provide magazine management data.
Provide monitoring data.
Magazine management active.
The magazine management functions are enabled for the current channel.
Tool management monitoring functions active.
The functions for monitoring tools (tool life and workpiece count) are enabled.
Value changes to the tool status ($TC_TP8) are taken into account in
toolCounterC.
Value changes to the remaining tool count ($TC_MOP4) are taken into account in
toolCounterC.
Value changes to the tool data are taken into account in the tool data update
service.
Value changes to the magazine data are taken into account in the update
service.
Buffer for tool data changes (DRAM)
For every first channel of a TOA. The magazine must also be configured in the
NC and PLC.
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
HMI sl (IM9)