Siemens SINUMERIK 840D sl Commissioning Manual page 299

When all interfaces are displayed, the default gateway is also output, i.e. the address of a
router to which all packages are sent that cannot reach their destination directly via a local
interface.
The default gateway is therefore a piece of data that applies to all interfaces and of which
there is only one instance. However, there is one interface via which it must be possible to
address the default gateway. This is displayed in brackets after the address.
show drives
Syntax:
Privilege level:
"sc show drives" shows the available remote file systems for a particular server. The server
name SERVER can be an NFS server, an SMB server or "TCU", which represents any USB
media that are connected to a TCU. For details of possible server names and entering a user
name (often required for SMB), see the description of the "sc connect" command.
Examples
Notation:
sc show drives someuser/somedomain@somepc # Windows-Server
Password: *******
//somepc/C$
//somepc/D$
//somepc/images
sc show drives someserver # NFS-Server
someserver:/export/home1
someserver:/export/home2
sc show drives TCU # TCU USB-Medien
TCU1:/dev0-0
TCU2:/dev0-0
All the available remote file systems of the relevant server are listed in the notation that is
expected by "sc connect".
● SMB shared drives on Windows servers always begin with "//", followed by the server
● USB memory devices on TCUs are a special form of NFS, and therefore also have the
NCU Operating System (IM7)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
name and the name of the shared drive. In NFS file systems, the server name is always
first, followed by a colon and then the export path.
Connection to SMB servers usually requires the entry of a user name (with domain, if
applicable) and a password.
same notation as NFS file systems. The specified path does not exist physically on the
TCU, but is converted there to USB by the NFS server.
sc show drives SERVER
none
Service Commands
3.4 Description of the actions
37