Siemens SINUMERIK 840D sl Commissioning Manual page 109

Entries
ToolBufferOnceOnTop
The following settings refer to markings in the lists.
true - Marking is displayed.
false - Marking is not displayed.
No entry - default setting
If several markings apply to one location, the most important information is displayed.
Entries
ShowSymbolActivePlace
ShowSymbolLoadPlace
ShowSymbolChangeInSpindlePlace
ShowSymbolActiveTool
ShowSymbolProgrammedTool
ShowSymbolActiveDNo
ShowSymbolActiveDNoInTool
ShowConflictPositionAndDirection
ShowConflictActiveToolWarning
HMI sl (IM9)
Commissioning Manual, 01/2008, 6FC5397-1DP10-3BA0
Meaning
Refers to the display of the buffer in the list sorted according to
magazine.
true – Buffer is displayed at the start of the list.
false – Buffer is displayed for each magazine. Only those locations
are displayed that are assigned to the magazine.
Meaning
Marking of the magazine location at the machining position.
true - Default setting applies for the "Revolver" magazine
type.
false - Setting for all other magazine types.
Selection of the magazine location at the loading position.
true - Default setting applies for all magazine types (except
Revolver is true).
false - Setting for the "Revolver" magazine type.
Marking of the magazine location at the change position.
true - Default setting applies for all magazine types (except
Revolver is true).
false - Setting for the "Revolver" magazine type.
Marking of the active tool.
false - Default setting.
Marking of the follow-on tool.
true - Default setting.
Marking of the active cutting edge.
false - Default setting.
Marking of the active tool through the marking of the active
cutting edge.
true - Default setting for configuration without magazine
management.
false - Setting for configuration with magazine
management.
Marking of a conflict; tool position and cutting direction do
not match.
true - Default setting.
Marking of a conflict; revolver magazine type and the active
tool are not at the the machining position.
true - Default setting.
Configuring tool management
13.10 General settings
103